1. The reason why the diesel engine cannot start: check the power supply, check the oil supply, consider the possibility of insufficient air intake, consider whether the intake compressive force is insufficient, consider whether the ambient temperature is too low, start the supporting output machinery with load, etc.
2. III: Plug-in open circuit or short circuit. The fuel injector harness, sensor harness, the whole vehicle harness plug-in is not plugged in or the harness is broken or short-circuited. Check the installation of the plug-in and check the connection of the line with a mimeter.
3. Circuit or electronic failure. The phenomenon of this failure is very sudden without any warning. The faults of the circuit include: fuse burnout, high-voltage coil breakage, low-voltage circuit breakage, central ignition wire falling off, split-fire head leakage, spark plug damage. Electronic failure mainly refers to the loss of function of the central computer control panel.
The reason why the diesel generator does not catch fire: 1. The friction surface is not lubricated in time. The lubricating oil film on the cylinder wall is damaged. Corroded by acidic substances. The friction surface is not lubricated in time. During cold start, the oil pump cannot immediately pump the lubricating oil to each friction surface. Make the initial lubrication conditions worse; the lubricating oil film on the cylinder wall is damaged.
The reason why the diesel generator can't catch fire: the friction surface is not lubricated in time. When cold started, it is impossible for the oil pump to immediately send the lubricating oil pressure to each abrasive surface. It makes the lubrication conditions in the initial stage worse; the lubricating oil film of the cylinder wall is destroyed.
The following are the reasons why the diesel generator can't catch fire: The engine oil line is not smooth. It is necessary to check whether the engine oil line is smooth. If you hear a squeaky sound from the fuel injector, it means that the oil line is fine.
Battery failure One of the most common reasons why the generator cannot start is battery failure. This may usually be caused by loose connection or sulfatization (the accumulation of lead sulfate crystals on the electrode plate of a lead-acid battery).
The first type: out of oil.We went out to rescue a car before. The fuel gauge showed that it was below the red line, so naturally it could not catch fire. The second type: the battery is out of power. It may be due to the power loss caused by the headlights not turned off for a long time or the battery life expires. Generally, it is recommended to replace the battery in time in 2 years.
The car battery is damaged. When the car battery is damaged, it is easy for the diesel car to fail to catch fire and naturally fail to start. In response to this situation, you need to go to a professional repair shop in time to deal with it and replace the brand-new battery. The oil transmission system is faulty. There is a blockage in the oil supply pipeline, resulting in the inability to come up the diesel.
Spark plug oil accumulation is a relatively common reason. The car has been starting for too long but has not started. The engine sprays oil to the spark plug. The oil will not burn without ignition. After a long time, it will cause spark plug oil, resulting in unable to ignite.
The main reasons why the diesel engine can't catch fire are as follows: 1. The problem of oil supply. The oil supply time is wrong, too early or too late. The atomization of the nozzle is not good, and the pressure of the oil pump is not enough. The oil line is not smooth, the diesel filter is blocked or there is too little diesel under the filter. There is a problem with the quality of diesel, such as water and oil in diesel.
Automated customs declaration checks-APP, download it now, new users will receive a novice gift pack.
1. The reason why the diesel engine cannot start: check the power supply, check the oil supply, consider the possibility of insufficient air intake, consider whether the intake compressive force is insufficient, consider whether the ambient temperature is too low, start the supporting output machinery with load, etc.
2. III: Plug-in open circuit or short circuit. The fuel injector harness, sensor harness, the whole vehicle harness plug-in is not plugged in or the harness is broken or short-circuited. Check the installation of the plug-in and check the connection of the line with a mimeter.
3. Circuit or electronic failure. The phenomenon of this failure is very sudden without any warning. The faults of the circuit include: fuse burnout, high-voltage coil breakage, low-voltage circuit breakage, central ignition wire falling off, split-fire head leakage, spark plug damage. Electronic failure mainly refers to the loss of function of the central computer control panel.
The reason why the diesel generator does not catch fire: 1. The friction surface is not lubricated in time. The lubricating oil film on the cylinder wall is damaged. Corroded by acidic substances. The friction surface is not lubricated in time. During cold start, the oil pump cannot immediately pump the lubricating oil to each friction surface. Make the initial lubrication conditions worse; the lubricating oil film on the cylinder wall is damaged.
The reason why the diesel generator can't catch fire: the friction surface is not lubricated in time. When cold started, it is impossible for the oil pump to immediately send the lubricating oil pressure to each abrasive surface. It makes the lubrication conditions in the initial stage worse; the lubricating oil film of the cylinder wall is destroyed.
The following are the reasons why the diesel generator can't catch fire: The engine oil line is not smooth. It is necessary to check whether the engine oil line is smooth. If you hear a squeaky sound from the fuel injector, it means that the oil line is fine.
Battery failure One of the most common reasons why the generator cannot start is battery failure. This may usually be caused by loose connection or sulfatization (the accumulation of lead sulfate crystals on the electrode plate of a lead-acid battery).
The first type: out of oil.We went out to rescue a car before. The fuel gauge showed that it was below the red line, so naturally it could not catch fire. The second type: the battery is out of power. It may be due to the power loss caused by the headlights not turned off for a long time or the battery life expires. Generally, it is recommended to replace the battery in time in 2 years.
The car battery is damaged. When the car battery is damaged, it is easy for the diesel car to fail to catch fire and naturally fail to start. In response to this situation, you need to go to a professional repair shop in time to deal with it and replace the brand-new battery. The oil transmission system is faulty. There is a blockage in the oil supply pipeline, resulting in the inability to come up the diesel.
Spark plug oil accumulation is a relatively common reason. The car has been starting for too long but has not started. The engine sprays oil to the spark plug. The oil will not burn without ignition. After a long time, it will cause spark plug oil, resulting in unable to ignite.
The main reasons why the diesel engine can't catch fire are as follows: 1. The problem of oil supply. The oil supply time is wrong, too early or too late. The atomization of the nozzle is not good, and the pressure of the oil pump is not enough. The oil line is not smooth, the diesel filter is blocked or there is too little diesel under the filter. There is a problem with the quality of diesel, such as water and oil in diesel.
Dairy products HS code verification
author: 2024-12-24 03:15How to analyze import export documentation
author: 2024-12-24 02:54Real-time supply-demand matching
author: 2024-12-24 02:50HS code-driven freight route adjustments
author: 2024-12-24 02:16How to navigate non-tariff barriers
author: 2024-12-24 01:08HS code-based container stowage planning
author: 2024-12-24 02:04Crude oil (HS code ) export trends
author: 2024-12-24 01:44Pre-export HS code verification steps
author: 2024-12-24 01:28Import data trends visualization
author: 2024-12-24 01:28Organic produce HS code verification
author: 2024-12-24 00:53218.42MB
Check336.87MB
Check268.71MB
Check999.71MB
Check214.78MB
Check777.51MB
Check914.72MB
Check734.78MB
Check184.91MB
Check228.36MB
Check645.11MB
Check165.52MB
Check863.72MB
Check793.74MB
Check375.86MB
Check766.89MB
Check332.81MB
Check194.57MB
Check762.12MB
Check988.18MB
Check971.67MB
Check127.99MB
Check411.98MB
Check511.93MB
Check292.76MB
Check487.34MB
Check112.45MB
Check516.22MB
Check389.95MB
Check652.15MB
Check321.38MB
Check419.37MB
Check917.95MB
Check869.56MB
Check273.39MB
Check114.41MB
CheckScan to install
Automated customs declaration checks to discover more
Netizen comments More
619 Raw leather HS code references
2024-12-24 02:44 recommend
1525 HS code-driven demand planning
2024-12-24 02:41 recommend
2568 How to use HS codes for tariff predictions
2024-12-24 01:50 recommend
2291 UK HS code duty optimization
2024-12-24 01:35 recommend
477 Mineral ores HS code tariff details
2024-12-24 01:20 recommend