How to comply with dual-use regulations

Motorcycle engine cleaning (teach you how to clean the motorcycle engine practical skills) Motorcycle engine cleaning is How to comply with dual-use regulationsthe most important part of motorcycle maintenance, which is a necessary skill for motorcycle friends. Motorcycle enthusiasts who often use motorcycles must learn how to clean the engine correctly in order to keep the motorcycle running efficiently and in good quality for a long time. The following are practical tips and steps for cleaning motorcycle engines: 1. Prepare the tools needed for cleaning, such as clean rags, acetone, gasoline, brushes, etc., as well as lubricants and other maintenance supplies. Two. To clean the outer surface, first of all, you must ensure that the outer surface of the engine is in a cool state, otherwise it will be damaged or explode due to high temperature.Wipe the surface of the engine with a clean rag and acetone (which can be replaced by gasoline) to remove a lot of dust and dirt. 3. After deep cleaning of the internal parts, open the oil cap and place an oil barrel. Then, carry out the step of releasing waste oil. Once the emptying process is completed, you can clean your filters and other parts to ensure that they are completely clean. Four. Clean the engine pump mixed with gasoline and some detergent, pour it into the pump, and then open the shell of the pump. Then, use the collecting oil barrel to receive the impurities from the water. You can also use compressed air flushing parts to make them deeper and cleaner. 5. Clean the engine step by step. Now you can use cleaners and oil brushes to clean the edges of the engine and the plates on the cover. All dirt and oil stains in all parts and areas should be removed and every place should be cleaned.If there are many invisible areas, use a power tool or a small brush to help you clean them. 6. After the installation and cleaning of the accessory oil seal is completed, you need to reinstall the accessories you have cleaned, such as the oil seal and other seals, and reinstall the filter. If you are not sure how to reinstall these parts, you can refer to the motorcycle service manual. 7. Refuel once all your accessories have been installed back on the motorcycle, you need to fill your oil. When filling oil, please make sure to add the correct oil according to the manufacturer's regulations and check how much oil you need to use. Apply the outer surface of the motorcycle evenly to make it shiny. Eight. Run the engine. Once all your work is completed, restart the engine and run. You need to make sure that the operating state and gear of the engine are normal. If you see any unusual conditions, be sure to stop and check immediately.According to the above practical tips, you should now be able to easily clean the engine of your motorcycle. Please note that the engine is the core part of the motorcycle. Before cleaning, you need to understand your motorcycle and use specific methods and tools to clean the engine of the motorcycle.

Contact Us
Phone：020-83484664