1. The shaking when the car starts is the gearbox Question. This kind of failure is generally more common in manual transmission models.
2. The common reason for car start-up jitter is that the throttle valve is too dirty or the fuel injector has too much carbon.When the engine accumulates too much carbon, the gasoline sprayed by the fuel injector head during cold start will be absorbed by a large amount of carbon accumulation, resulting in excessive mixing gas during cold start and difficulty in starting.
3. This kind of jitter may be caused by indentation when the transmission gear and the transmission shaft mesh. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting. Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
1. The engine foot shakes. The automatic transmission car shakes badly when it is in the forward gear but has not started. It is likely that the engine foot has failed. In the process of using the car, the wear rate of the engine foot is much higher than that of other parts. After a long time or the engine foot Deformation and other problems may occur in certain quality defects.
2. This kind of jitter may be caused by indentation when the transmission gear meshes with the transmission shaft. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting.Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
3. Serious engine carbonization: Cars always have the problem of carbonization, including cylinder carbonization, throttle carbonisation, spark plug carbonation, intake carbonation, etc. When the engine accumulates too much carbon, it will affect the ignition energy, intake efficiency and air-fuel ratio of the car, resulting in unstable power output of the car, idling and acceleration jitter.
Solution: Check the oil pressure and replace the parts if necessary. Aging of engine parts. Car jitter is also related to the aging of engine feet (also known as claw pads).
When judging, set up the drive first.Bridge, plug the front wheel with safety plugs, start the engine and gradually change to high-speed gear, so that the drive wheel reaches the final test vibration speed. If the car body and the steering wheel shake at this time, it is the vibration caused by the transmission system.
It is relatively simple to solve this problem. You only need to replace the aging foot mat. It is recommended that the car owner choose the original accessories when replacing the foot mat.
Trade data for FMCG sector-APP, download it now, new users will receive a novice gift pack.
1. The shaking when the car starts is the gearbox Question. This kind of failure is generally more common in manual transmission models.
2. The common reason for car start-up jitter is that the throttle valve is too dirty or the fuel injector has too much carbon.When the engine accumulates too much carbon, the gasoline sprayed by the fuel injector head during cold start will be absorbed by a large amount of carbon accumulation, resulting in excessive mixing gas during cold start and difficulty in starting.
3. This kind of jitter may be caused by indentation when the transmission gear and the transmission shaft mesh. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting. Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
1. The engine foot shakes. The automatic transmission car shakes badly when it is in the forward gear but has not started. It is likely that the engine foot has failed. In the process of using the car, the wear rate of the engine foot is much higher than that of other parts. After a long time or the engine foot Deformation and other problems may occur in certain quality defects.
2. This kind of jitter may be caused by indentation when the transmission gear meshes with the transmission shaft. This problem may exist in many powershift models, while AT and CVT models usually do not tremble when starting.Automatic manual transmission models such as DSG and DCT may tremble when changing gears.
3. Serious engine carbonization: Cars always have the problem of carbonization, including cylinder carbonization, throttle carbonisation, spark plug carbonation, intake carbonation, etc. When the engine accumulates too much carbon, it will affect the ignition energy, intake efficiency and air-fuel ratio of the car, resulting in unstable power output of the car, idling and acceleration jitter.
Solution: Check the oil pressure and replace the parts if necessary. Aging of engine parts. Car jitter is also related to the aging of engine feet (also known as claw pads).
When judging, set up the drive first.Bridge, plug the front wheel with safety plugs, start the engine and gradually change to high-speed gear, so that the drive wheel reaches the final test vibration speed. If the car body and the steering wheel shake at this time, it is the vibration caused by the transmission system.
It is relatively simple to solve this problem. You only need to replace the aging foot mat. It is recommended that the car owner choose the original accessories when replacing the foot mat.
HS code-focused compliance audits
author: 2024-12-24 02:06Commodity-specific import licensing data
author: 2024-12-24 02:00Trade data for market diversification
author: 2024-12-24 01:37Livestock feed HS code references
author: 2024-12-24 01:00HS code applications in compliance software
author: 2024-12-24 02:43Medical PPE HS code verification
author: 2024-12-24 01:32Global trade analytics for decision-makers
author: 2024-12-24 01:30Latin America export data visualization
author: 2024-12-24 00:46Pharma finished goods HS code references
author: 2024-12-24 00:22791.22MB
Check574.74MB
Check818.78MB
Check291.79MB
Check255.58MB
Check954.48MB
Check822.43MB
Check984.88MB
Check956.62MB
Check537.55MB
Check391.97MB
Check773.63MB
Check539.12MB
Check536.92MB
Check136.61MB
Check581.85MB
Check883.15MB
Check311.93MB
Check156.89MB
Check851.72MB
Check688.76MB
Check566.19MB
Check472.16MB
Check828.92MB
Check455.31MB
Check312.48MB
Check226.95MB
Check725.61MB
Check984.28MB
Check255.18MB
Check677.86MB
Check944.68MB
Check515.64MB
Check275.99MB
Check561.86MB
Check171.33MB
CheckScan to install
Trade data for FMCG sector to discover more
Netizen comments More
1062 Gemstones HS code references
2024-12-24 02:46 recommend
2378 Global trade barrier analysis
2024-12-24 02:24 recommend
1358 Trade data for transshipment analysis
2024-12-24 01:47 recommend
746 HS code adaptation for local regulations
2024-12-24 01:29 recommend
1981 Advanced trade data analytics techniques
2024-12-24 00:56 recommend