Global trade route simulation

Engine Overheating refers to the abnormal increase in engine temperature,Global trade route simulation resulting in engine failure and difficulty in vehicle operation. This problem not only affects the performance and safety of the vehicle, but also easily leads to serious mechanical failures. I. Causes of thermal decay 1. Lack of water in the engine and the loss of coolant will cause the temperature to rise and damage your engine. Therefore, every time you refuel, you should open the engine cover to check whether the amount of water in the water tank is sufficient and refuel it in time.Two. Water pump failure The water pump is the core of the engine cooling system. When the water pump does not work, the overheated engine coolant is not circulated, which may lead to thermal decay of the engine. At this time, the water pump needs to be replaced in time. 3. Engine failure. Wear inside the engine usually leads to thermal decay. This is especially common in some old vehicles. When there is too much gap between the piston and the cylinder block, it will cause the engine to emit too much heat, resulting in overheating or thermal decay. Four. The throttle failure engine failure or throttle failure may also cause thermal decay of the engine. The throttle valve usually closes when the engine is not running normally. If your vehicle encounters such problems, you can consider repairing or replacing the engine as soon as possible. II. How to prevent 1. Regularly replace the coolant of different brands of cars. The interval between changing the coolant is also different.Usually, the interval between replacing the coolant also determines the life of the pump. Therefore, check the coolant of the engine regularly to ensure that your vehicle maintains a normal temperature. Two. Regular vehicle maintenance is very important, and it is very helpful for the long-term use of your vehicle. Regularly check the engine, water pump, radiator, etc., so as to prevent possible problems in advance. 3. Avoid overloading, overloading or high-speed driving will lead to excessive heating of the engine, further exacerbating the abnormal increase in engine temperature. Therefore, pay attention not to overload or speed up excessively. If you need to drive for a long time, you need to stop and take a break from time to time. III. How to deal with engine thermal decay If your car encounters engine thermal decay, the following steps can help you cool down: 1.Park the vehicle in a safe place, turn off the engine, and pull up the handbrake. Two. Open the radiator cover and wait for the car engine to cool down, then add water or coolant to the radiator. Pay attention to add it after the water temperature drops to avoid causing a slight burst of the engine cylinder. 3. Start the car and let it idle when it is parked (that is, in the idle state, step on the accelerator to accelerate to about 3000 speed) 4. When the vehicle begins to inhale free air and output engine exhaust gas, it proves that the engine has begun to ventilate and dissipate heat, while waiting for the water temperature to drop. If there is no water in the water tank of the car, the water tank needs to be replaced. In a word, prevention is more important than treatment. To maintain the normal use of the vehicle, it is necessary to strengthen the maintenance and upkeep. If your car experiences engine thermal failure, you can take some simple measures to respond to the emergency.When dealing with this problem, you should always pay attention to your own safety. Always remember that prevention is more effective than emergency measures!

Contact Us
Phone：020-83484664